Beech Bonanza V35 from the Premier Collection

Flying the Bonanza V35

Install the Beech Bonanza V35 to your FS2004 or FS2002 \aircraft folder. If you haven't already done so, follow the instructions on our installation page.

Press the 'S' key to see the 2D cockpit; press the 'S' key again to see the 3D cockpit and twice more to see the aircraft from the spot plane view. Here's a quick walk around:

  • Press 'E' to start the engine.
  • Press the stick forward and back to see elevators move up and down.
  • Shift + 'E' to see the canopy open and close
  • In the 3D cockpit view you'll see the stick and pedals move.

Takeoff
Taxi out to the runway.

Normally, you won't need flaps for takeoff. Apply full throttle and you'll quickly accelerate.

Rotate at 70 knots. When abeam the end of runway, retract the landing gear. Accelerate to about 95 mph.

Climb to desired altitude.

Landing

Approach speed is about 105 knots.

On short final the extend flaps and lower thelanding gear and you'll continue the approach at 85 knots.

Stall speed is about 70 knots. Set down on the main gear and ease down onto the nose wheel.

Revision 6290